The installation did not go *fine*. The installation proceeded until the Mac tried to reboot to Windows 10. This is where the installation failed. If you would had successfully completed the Setup.exe application included with the Windows Support Software, then the installation would have gone *fine*. This includes a reboot with all the hardware working.

The following debug information could have been provided:

 - The version of OS X (macOS)
 - The output from `diskutil list`
 - The output from `sudo fdisk /dev/disk0` (This may require first booting to Recovery mode.)
 - A listing of the files and folders in the root folder of the USB Windows 10 installer flash drive. 

You stated the following:

>I have downloaded Win 10 ISO from Microsoft site and there was issue with Bootcamp where I have to edit a file to make Bootcamp work for Win 10 version

You may have edited the file so that Windows 10 was installed to UEFI boot. Most (if not all) 2011 Macs installed Windows to BIOS boot. This can be confirmed by providing the debug information given above.

You stated the following:

>another issue came when USB drive where I was downloading, it was always failing because of file size limit ( some file was over 4GB and FAT/exFAT has 4GB limit on file so I found out another video where big file was spilit into 2 so another ISO file was created where bigfile was split in two files.

This problem was solved for most (if not all) Macs by provided a firmware update included with High Sierra and newer versions of macOS. This update allows Macs to boot from ExFAT formatted volumes. Evidently, your version of the Boot Camp Assistant did not use the ExFAT format when creating the USB Windows 10 installer.

Regardlessly of whether you have installed Windows to BIOS or UEFI boot, you could first determine the boot method, then reinstall Windows to boot using the other method. (Or just change the boot method, but this requires advanced knowledge of the Windows installer CLI.)

--------

Another solution would be to first install Windows 7 or 8.1, then upgrade to Windows 10. This would probably require purchasing a Windows 7 or 8.1 product key. The advantage to this method is Apple designed your Mac to run the 64 bit versions of both Windows 7 or 8.1, so there should be no problems using the Boot Camp Assistant to install.