11

I'm not sure if I have an issue or if what I am seeing is by Apple-design. I have an iPad Pro (11.4) that I have the Personal Hotspot switched on.

  1. My iPad Pro is active and screen on.
  2. I connect my iPhoneX (11.4) to the iPad Hotspot.
  3. Everything works fine.
  4. I sat working on laptop and then the iPhone X and iPad screen locked. After X minutes I then unlock iPhone to check email etc..
  5. The iPhone X has disconnected from the hotspot and is back to using the cellular plan on my iPhone. If I go to Settings -> Wi-Fi then my iPad is not listed.
  6. To make the hotspot reconnect I have to go back to my iPad and toggle the Personal HotSpot switch (On -> Off -> On).

Is this by design or not? Should the iPhone remain connected if the devices screen lock?

  • Been getting the same issue but only since 11.3/11.4. Before that didn't have this "feature". Also getting a lot of general hotspot connection issues at the same time necessitating regular reboots or airplane mode switches to kick it into life. – Neil Pike Sep 9 '18 at 20:07
7

After further experimentation I found that if I create a Bluetooth connection (pair) between iPhone/iPad it stays connected throughout screen locks etc.

| improve this answer | |
  • Confirmed this also works with two Iphones – Dannie P Jun 24 '19 at 16:46
0

I think it's partially by design. Whenever my son wants to connect to my Personal hotspot, I have to open the Personal Hotspot screen, even if it's already on and he's got the network/password saved away. But, I don't have to toggle it off/on.

Also, disconnecting from a hotspot is automatic when the client device sleeps.

| improve this answer | |
  • its such a nightmare if you connect a router to the tether – SuperUberDuper May 18 at 10:08
0

I had the same issue with 2 iPhones. It appeared that iOS 12 is saving power by disabling Hotspot broadcast then the signal disappears afterwards.

To fix this Go to iPhone setting -> 'Battery health' and disable the battery saving mode. You find a small link under 'Peak Performance Capability', the option once disabled disappears and cannot be enabled again.

| improve this answer | |

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .