Is it possible to upgrade Mac Pro 2.1 to 5.1 firmware? Does it also make sense -- is the hardware different? Has it been done before?

2 Answers 2


No, it is not possible, so it doesn't make sense and hasn't been done before.

Yes, the hardware is different (considerably). It's a completely different board and layout where the CPU and RAM are. The difference on the cases is around the FireWire 400 ports.

The 1,1 could be flashed to 2,1, and the 4,1 to 5,1; that mainly buys you newer CPU support (well, newer compared to the original firmware's capabilities).

The 1,1 and 2,1 have 32-bit EFI firmware; many have searched for ways to change that without much success (see MacRumors' forums). One answer I read suggested swapping out the motherboard.

All three (1,1-3,1) use older DDR2 frame-buffered DIMM's, whereas the 4,1/5,1 use DDR3 DIMMs. The supported CPU's are also different.

  • While you CANNOT flash a 2,1 to a 5,1 there is something in the other answers that needs cleared up. The Mac Pro 3,1 is NOT 32bit EFI as suggested above. It is 64bit EFI. Only the 1,1/2,1 have 32bit EFI and need pikes bootloader up to El Cap. The 3,1 supports El Cap officially and will take even Catalina with a Patch. Jul 2, 2019 at 14:50
  • Corrected the comment about 3,1 being 32-bit. Jul 3, 2019 at 15:05

Dont let him put you off.

You can at least use Pikers boot efi to convert it to 64 bit and run any MacOS up to El Capitan. I have done this.

  • The question wasn't about running Yosemite or El Cap on a 2,1. Pike's boot loader doesn't convert a 2,1 to a 5,1. Jul 3, 2019 at 15:07

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .