2

My Cinema Display bit the dust, and all the symptoms seem to point to the 150W power supply brick, which is apparently not an uncommon problem with those models.

New power supply bricks are close to $200. Ouch. Usually one bad component in a power supply is a lot cheaper than that, and I've soldered together a power supply or two in my day.

Unfortunately, the Cinema Display power supply is built like the monolith from "2001", with no apparent way to open it. Can I use a thin putty knife to crack it open, like the old Mac minis? Is there some way to get in through the line-in plug? Is it sealed in a way that can't be opened, but maybe there's a safe(-ish) place to saw through to get inside?

1

Someone did it.

There's no good way to open it. Use a Dremel to carefully cut around the seam until it was thin enough to crack apart.

There's one huge capacitor (Rubycon KXW 450V 150 uF) that needs to be discharged before the power supply will start up.

Be careful, because it's charged to over 100 volts. Solder a 600 k ohm resistor across it to bleed off the charge a little faster.

0

If it's anything like this power supply, you'll need to saw it open. Apple's "non-repairable" devices are thermally or chemically welded, and there's usually no clean way to open them up.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .