Take the 2-minute tour ×
Ask Different is a question and answer site for power users of Apple hardware and software. It's 100% free, no registration required.

I would like to open the MBA, i don't have the screwdriver that fits this:

MBA screw

Is there a way to remove the screws without the 5 points pentalobe required?

The ideal solution would be to do this without damaging the screws.

share|improve this question
4  
Anything but the correct tool will damage the screws. You can form your own tool with a file and an old screwdriver, but it will damage the screws unless you are incredibly precise. You can use a plastic like ShapeLock to form your own screw driver tip, but it probably won't have enough force to unscrew or screw them successfully. You could use superglue to attach a smaller hex wrench to the screw, then nail polish remover to detach it. But all of these methods will very likely damage the screw or the macbook. You can get the correct tool from inexpensively and quickly. –  Adam Davis Apr 3 '12 at 15:09
add comment

2 Answers

up vote 13 down vote accepted

You cannot safely remove it without the proper tool and the correct touch. You want to place the driver on the tangent to the case (the screws enter at an angle - not vertical compared to the keyboard plane.

iFixit.com and other places sell the pentalobe tool for less than $15 and it's money well spent to avoid needing to get Apple to replace the screws should you strip them.

share|improve this answer
    
A giant plus one to this answer. This isn't one of those times when vise grips is the correct answer—use the proper tool, or take the unit to someone who will. –  jaberg Apr 3 '12 at 17:24
    
Well, indeed I hoped for a magic trick I guess. If as I suspect Apple will use these on the next MacBooks, I will definitely buy one of these screw drivers then. –  Coyote Apr 3 '12 at 19:57
    
It's a great question and will be very helpful for others, and it's a very natural thought. "If I could just get enough purchase from tool X" –  bmike Apr 3 '12 at 20:26
add comment

I managed to do this with a 1.2mm flathead, it obviously doesn't have as much torque as a pentalobe driver, but it doesn't strip the heads if you're careful.

Also, this trick works, but you need the right pen (hard clear bic): http://www.youtube.com/watch?v=ONd7quApjGM

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.