I use a unibody Mac laptop to read recipes or listen to music while in the kitchen. The wireless disconnects sometimes. How can I prevent this?
This really has nothing to do with unibody or Macs, but is rather due to physics. I'm guessing that you're cooking using a microwave oven or have it running nearby when you're using your laptop.
The 802.11b WLANs operate in the 2.4 GHz band. Unfortunately, microwave signals also fall in the same frequency band, and hence can cause interference with your wireless signal. If the interference is too high (depending on how your home is setup, how close the microwave oven is, etc.), your receiver can drop the connection.
An alternative to this would be to use a routing device that uses 802.11a. This operates at 5 GHz, which is outside the interference band and you won't notice this problem. However, the drawback is that since it's higher it frequency, it attenuates faster. This means that it will not travel as far as the 802.11b and will not penetrate through walls, etc. So if you have a big house, this might not be feasible unless if you want to set up multiple hotspots. From the linked wiki article:
You can also programmatically test this. You can get your wireless details from the command line with
The entries corresponding to
In the figure, you can see the change in wireless signal strength and interference as I walk from near the router (at time 0) into the room farthest away. The point to note here is that signal decreases, but noise background remains at the same level.
Then I return to the dining (next to the kitchen) and turn the microwave on for a minute (highlighted time periods). You can see how the interference increases and is higher in the next trial, when I move it to the kitchen (but not near the microwave). Note that these levels are in decibels, which means that a 3dB increase implies a doubling of interference.
The third time, I put it right next to the microwave and my laptop dropped the signal because the interference was just way too high. You can get a glimpse of how high it was, when you see it drop down to normal levels after turning the microwave off. All this while, the signal strength remained the same.
Summary: Your kitchen appliances are interfering with your signal and if you happened to be far enough from the router that your signal levels are also low, you can experience difficulties even without being that close to the appliance.
When you are running the microwave oven, your wireless network may sometimes be disrupted enough to disconnect until the microwave finishes cooking.
If it happens at other times, another electrical appliance may be creating enough interference to cause a disconnect. For instance, if your laptop is too close to an induction cooktop, or to a particularly old high power blender, such as an old vita-mix. Older generation applicances aften do not follow the latest EMC and FCC standards for electromagnetic noise and radiation, and older devices with electrical motors often produce a significant amount of noise due to old brushes.
Narrow down which appliance is the problem by trying them out one at a time and seeing which one causes the disconnection.
If it's the microwave, you can try relocating the laptop or wireless router, but a new microwave will probably have the same issue.
I resolved the issue in my home by installing a wireless router capable of the 802.11a or 802.11n band, which run at 5GHz, which the microwave does not conflict with. Make sure your Mac supports 802.11a or n before trying this.
If it's another appliance, you should be able to resolve the problem by replacing the appliance.
You may also find good results by moving your laptop to another area in the kitchen away from the problem appliance, and letting it run on battery power, since some of these emissions can be carried over the AC wiring. A higher power or more recent router may also resolve the problem, as well as relocating the router closer to the kitchen.
Simple Version of the other answers:
You're kitchen appliances' microwaves are jamming the Wi-Fi from your router and preventing it from getting to your mac.
I got mad today and started to test my microwave. I just placed 2 baking plate on the top of microwave like one covering backside and another covering right side gap because my microwave is placed in the corner of kitchen. So I just covered the gap on the top 2 sides only. I started to heat my coffee for 1 min and I do see this worked and did not disconnect my wireless connection.
I again did the test one more time to make sure it works and worked. So my conclusion is that you need to shield your microwave is the simple solution.