Take the 2-minute tour ×
Ask Different is a question and answer site for power users of Apple hardware and software. It's 100% free, no registration required.

Configuration:
Windows XP Pro + SP3
iPod Nano 1st generation, firmware version 1.3.1
iTunes 10.4.1.10


When I connect the iPod to the PC iTunes says

iTunes has detected an iPod in recovery mode. You must restore
this iPod before it can be used with iTunes

OK, that's what I do. I get a message that

Your iPod has been restored to factory setting, and is
restarting. Please leave your iPod connected. It will
appear in the iTunes window after it restarts.

Then on the iPod the Apple logo appears for a few minutes, which then switches to a "Do not disconnect" message. Again after some time the recovery mode reappears in iTunes. I've cycled through this a few times, even on a different USB port, but no avail. If I disconnect the iPod I can walk through the menus, and reset it. The music of course has gone.

Is there a way to get the iPod out of recovery mode, other than with the iTunes function?

share|improve this question
add comment

migrated from superuser.com Sep 30 '11 at 16:31

This question came from our site for computer enthusiasts and power users.

2 Answers

up vote 2 down vote accepted

It may be a drive letter conflict in Windows. Go ahead and try the steps listed here: http://support.apple.com/kb/TS1493#changedrive

share|improve this answer
    
That's exactly it. I found it out myself as well, but this is the right answer, so you get the votes –  stevenvh Sep 30 '11 at 16:38
add comment

I looked a bit further in it and I found the solution here. It appears the drive letter assigned to the iPod conflicted with another drive. Assigning a free drive letter as on the Apple support page solved the problem.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.