Take the 2-minute tour ×
Ask Different is a question and answer site for power users of Apple hardware and software. It's 100% free, no registration required.

the screen on my macbook air has broken, It is only hanging on by a couple of wires and it lights up but doesn't do anything else. I want to sell it for parts but obviously want to get all my data off first. I have an external cd drive with the restore cd in but when I press C on boot I obviously can't see anything. Can I somehow connect it to an external monitor? Or is there another way of doing this?

Thanks

share|improve this question
    
what is the model of your MacBook Air? –  user6124 Jun 29 '11 at 11:25
    
it says model number is A1237 –  user7533 Jun 29 '11 at 11:41
add comment

3 Answers

You should be able to connect it to an external monitor. All you need to do (in principle) is this:

  1. Close lid, let computer go to sleep
  2. Connect both the power supply and external monitor

About a second after you connect the external monitor, it should wake up and direct all output to the external monitor. (It will only do this if the lid is closed, external power is connected, and something is connected to the video output port.)

Note that depending on the speed of your computer and other factors, it may take a little while for anything to show up on the screen. Give it at least a minute if you don't see anything at first, before assuming something didn't work.

share|improve this answer
add comment

Remove the hard drive from the MacBook Air and then put it into a hard drive enclosure.

See this for information on how to remove the hard drive. However, the hard drive enclosure needs to be of a special type (ZIF 1.8" like this one)

share|improve this answer
    
what if the disk is an SSD of the new kind? –  Agos Jun 29 '11 at 21:39
1  
@Agos the OP's MacBook Air uses the old one –  user6124 Jun 30 '11 at 1:53
add comment

To complete the trifecta of answers, you can also network boot the Air to another mac running deploy studio.

It's some work to set up the deploy studio, but you can easily automate the erase process with a few known single key commands. Once you have the erase option figured out, you don't need to see the screen, just a working keyboard.

The other downside is if an error pops up, you might not be able to read it.

This is less easy than removing the drive or hooking an external monitor, but once set up, it's useful software to have around.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.